@article { author = {Hoseinzadeh Dehabadi, Ali Asghar and Argany, Meysam and Darvishi, Ali}, title = {Investigation and Extraction of Building Demolitions due to Earthquake using High Resolution Satellite Images}, journal = {Environmental Management Hazards}, volume = {6}, number = {3}, pages = {239-257}, year = {2019}, publisher = {}, issn = {2423-415X}, eissn = {2423-4168}, doi = {10.22059/jhsci.2019.287833.496}, abstract = {Earthquake is one of the natural disasters that if occurs strongly in high population areas, will create great human catastrophe. Earthquake can provide considerable life and financial devastating effects, especially in urban regions. Observation of damaged buildings map is crucial for crisis management experts and helps them guide rescue teams to damaged locations in short period of time. Remote sensing and geographic information system is an efficient tool of rapid survey of condition of damaged buildings after the earthquake in urban regions. This research has been conducted with the aim of identification of demolished buildings due to earthquake by very high resolution satellite images and comparison of available efficient methods. To achieve these goals, very high resolution satellite images of Bam city, before and after the earthquake, and the observed damage map of the region were used. In this study, the best and the most appropriate textural indices were chosen after calculation of textural features of images by statistical analysis of logistic regression and correlation. Then, the condition of buildings demolition was classified by optimum obtained textural values and implementing Multilayer Perceptron (MLP) neural network systems, Adaptive Neuro-Fuzzy Inference System (ANFIS), and Support Vector Machines (SVM). Finally, the accuracy of all the presented techniques were compared with each other and the best proposed technique was selected and presented. According to the results, all the three MLP, SVM and ANFIS methods were good for classification of degrees of buildings demolition, but ANFIS method was better with 1% in overall accuracy, 4% in kappa coefficient, and 1.7% in RMSE. Introduction Occurrence of natural disasters, especially in urban regions, causes abundant life and financial damages. Earthquake is one of the natural disasters that if occurs strongly in high population areas, will create great human catastrophe. The rescue of people from under debris and damaged regions after the earthquake leads to a reduction in life losses, but this subject can have the maximum efficiency only when the fast rescue operations have plan and goal. This is one of the most important concerns of crisis management managers in every country. Buildings are among regions with the highest destruction by earthquake. To obtain buildings demolition map, one can perform through ground operations and identification groups with high accuracy, but this needs plenty of time and requirements. Recent advances about satellites from spatial, spectral, and temporal resolution point of view and even advance in image processing areas also has provided the observation possibility of changes in target regions through image analyses. Remote sensing (RS) and Geographic Information System (GIS) is an efficient tool for fast surveillance on damaged buildings in urban regions after the earthquake. The goal of this research is identification and extraction of buildings demolition due to earthquake by investigation of textural features of terrains in image and comparison of building demolition classification techniques and presentation of the best technique considering the study area. Methods and Materials The case study in this research is Bam city, one of the cities of Kerman province located in Iran country. On Friday, January 05, 2004 at 5:26 (local time) a 6.6 Richter scale and a depth of 8.5 Kilometers earthquake occurred in Bam city and lasted for 12 seconds. QuickBird satellite images with 61 centimeters resolution were used in this research. Demolition map was also utilized as a helping data (ground) for determination of location of buildings and a basis for assessment of this study that Yamazaki et al. provided this map as intersections of location and condition of degrees of buildings demolition [16]. To perform more accurate calculations, initially a pre-processing step performs on raw data before processing on images. Considering the goal of this research, buildings are required to be extracted out of images before and after the earthquake. Then, the textural features of images were extracted and the best textural descriptors for determination and identification of buildings demolition were selected by statistical methods. To achieve demolition map, there is a need to models for classification and identification of degree of demolition. In this research, three Multilayer Perceptron (MLP) Neural Network, Adaptive Neuro-Fuzzy Inference System (ANFIS), and Support Vector Machines (SVM) techniques were employed and finally an accuracy evaluation and comparison of these techniques have been done. Discussion and conclusion After extraction of buildings from images and calculation of textural features, mean obtained numerical values for every constituent pixels of building has been calculated for results assessment and added to building descriptive table as a quantitative parameter and then all of the descriptors were normalized. In determination of the demolition due to earthquake by texture analysis, one can employ the assumption that the demolished areas have more irregular texture than the normal areas [8]. In this research, overall eight descriptors, including statistical first order and Haralick textural descriptors were implemented. Then, by logistic regression, the best texture was chosen that Variance, Dissimilarity, Homogeneity, and Contrast descriptors were used in identification and rehabilitation of demolished and normal buildings with the highest accuracy than the others. The models and techniques were also run by 206 educational samples and chosen textural images as the four input layers. The outputs are classification of degrees of buildings. According to the results, by running the aforementioned models and comparison of overall accuracy, kappa coefficient, and RMSE, it has been determined that all the MLP, SVM, and ANFIS methods are similar for classification of degrees of buildings demolition, but have minor differences in accuracy, so that maybe by a look at demolition maps, the differences are not clear and there is a need to more precision. Totally, neuro-fuzzy method was better than the other two methods with 1% difference in overall accuracy, 4% in kappa coefficient and 1.7% in RMSE. However, the ANFIS method reached the first rank with minor difference. The superiority of this method can be interpreted because of combination of the neural network system and fuzzy logic concepts and simultaneously implementation of both of them.}, keywords = {earthquake,Building Demolition Map,Multilayer Perceptron (MLP) Neural Network,adaptive neuro-fuzzy inference system (ANFIS),and Support Vector Machines (SVM)}, title_fa = {بررسی و استخراج تخریب‌های ساختمانی ناشی از وقوع زلزله با استفاده از تصاویر ماهواره‌ای با توان تفکیک زیاد}, abstract_fa = {زلزله یکی از بلایای طبیعی است که در صورت شدت داشتن در مناطق پرجمعیت، فاجعۀ انسانی بزرگی را ایجاد خواهد کرد. زلزله ممکن است آثار ویرانگر جانی و مالی چشمگیری را به‌ویژه در مناطق شهری داشته باشد. مشاهدۀ نقشۀ ساختمان‌های آسیب‌دیده برای متخصصان مدیریت بحران حیاتی است و به آنها کمک می‌کند تا گروه‌های نجات را در کوتاه‌مدت به محل‌های آسیب‌دیده هدایت کنند. سنجش از دور و سیستم اطلاعات جغرافیایی، ابزاری کارامد برای بررسی سریع وضعیت ساختمان‌های آسیب‌دیده در مناطق شهری پس از زلزله محسوب می‌شود. این پژوهش با هدف تشخیص ساختمان‌های تخریب‌شدۀ ناشی از زلزله با استفاده از تصاویر ماهواره‌ای با قدرت تفکیک بسیار زیاد و مقایسۀ روش‌های پربازده موجود انجام گرفته است. برای رسیدن به این اهداف از تصاویر ماهواره‌ای با قدرت تفکیک بسیار زیاد مربوط به قبل و بعد از زلزله در شهر بم و نقشۀ تخریب مشاهده‌شده از منطقه استفاده شده است. در این پژوهش پس از محاسبۀ ویژگی‌های بافتی تصاویر با استفاده از تحلیل آماری رگرسیون لجستیک و همبستگی، بهترین و مناسب‌ترین شاخص‌های بافتی انتخاب شدند. سپس با استفاده از مقادیر بافتی بهینۀ به‌دست‌آمده و پیاده‌سازی سیستم‌های شبکۀ عصبی پرسپترون چندلایه (MLP)، سیستم استنتاج عصبی- فازی سازگار (ANFIS)، روش الگوریتم ماشین بردار پشتیبان (SVM)، وضعیت تخریب ساختمان‌ها طبقه‌بندی شد. در نهایت، دقت همۀ روش‌های ارائه‌شده با یکدیگر مقایسه و بهترین روش پیشنهادی انتخاب و معرفی شد. با توجه به نتایج، هر سه روش MLP، SVM و ANFIS برای طبقه‌بندی درجات تخریب ساختمان‌ها خوب بود، اما روش ANFIS با اختلاف 1 درصد در دقت کلی و 4 درصد در ضریب کاپا و 7/1 درصد در RMSE بهتر بود.}, keywords_fa = {روش الگوریتم ماشین بردار پشتیبان (SVM),زلزله,سیستم استنتاج عصبی- فازی سازگار (ANFIS),شبکۀ عصبی پرسپترون چندلایه (MLP),نقشۀ تخریب ساختمان}, url = {https://jhsci.ut.ac.ir/article_74089.html}, eprint = {https://jhsci.ut.ac.ir/article_74089_318e463db7d9b22d383310305e566f2a.pdf} }